A. What you'll need:

1. Bucket filled with water
   
   
2. 2-liter bottle with cap
   
   
3. Bowl piece
   

B. Assembly of your homemade bong

1. Cut the bottom of the 2-liter plastic bottle.
   
   
2. Take the bottle cup, and puncture a hole in which you'll fit in the bowl piece tightly. This can later be air tightened with some candle wax if needed.
   
   
3. Fill the bucket with cold water at the level needed for the bottle to be almost full when it is rested on the bottom of the bucket.

C. Smoking

1. Uncap the bottle and place it bucket so that it is almost full with water.
   
   
2. Fill the bowl, which should be screwed in the bottle cap and close the bottle with it.
   
   
3. Align your ignited lighter over the bowl and gradually pull the 2lt.. bottle up -
   this will cause air to rush through the burning bowl, replacing the water that was inside before, with rich smoke.
   
   
4. Once the bottle is full, remove the bowled cap and place your hand over the top. It's smoke time! Exhale all air from lungs, then put your mouth over the opening and let the bottle fall to the bottom of the bucket. Open your lungs and let the pressure from the water filling the bottle shotgun the smoke into your lungs.
   
   
5. Now, if you liked that believe us you will love your new BUKKET, which is based on the same principals, but is much simpler, fun and cleaner, check it out now !